^ This

I would almost say that Broadcom is probably worse off than most of the rest in your list combined. 😠

I have Wemo light switches, outdoor plugs, mini plugs, and the original plug. Since they are HomeKit enabled you don’t have to set them up with the Wemo app. You can set them up directly from HomeKit. I’ve never downloaded a Wemo iOS app.

Sucks that they aren’t supported anymore but my warranty ran out a while ago. I may lose firmware updates with patching for security vulnerabilities but I have these running on an IOT VLAN that is very restricted and only has the access that my firewall lets it access.

Ok, I grabbed a few screen shots for you as well. Here is a site that will link you to MEBx setup that enables AMT: http://h10032.www1.hp.com/ctg/Manual/c03883429

When power on your ProDesk G3, you can access the MEBx setup by pressing Ctrl+P or they also say F6 or Escape will get you there. Intel AMT runs on a different IP address than what your OS gets. You can assign DHCP or a static IP address and setup your admin password. You can then access the portal from http://ipaddress:16992/ There should be a method of access what would show on the screen through a KVM like access but I use MeshCentral for that so I couldn’t tell you how to do it without.

Hopefully, that gives you a start. Feel free to reach back out if you have any questions. Thank you!